Setup; Ac Power; Fuse Replacement - Chauvet LED FOLLOWSPOT 75ST User Manual

3. S
ETUP

AC Power

Fuse
Replacement
LED Followspot 75ST User Manual Rev. 6
This product has a switchable power supply that can work with an input voltage of
120 VAC or 230 VAC, 50/60 Hz.
To determine the power requirements for this product (circuit breaker, power outlet, and
wiring), use the current value listed on the sticker affixed to the product's back panel, or
refer to the product's Technical Specifications
the product's average current draw under normal conditions.
Always connect this product to a protected circuit (circuit breaker or fuse),
making sure that it has an appropriate electrical ground to avoid the risk of
electrocution or fire.
Never connect this product to a rheostat (variable resistor) or dimmer circuit, even
if the rheostat or dimmer channel serves only as a 0 to 100% switch.
Follow the instructions below to change the fuse, if necessary.
Disconnect this product from power before replacing the fuse.
1. Disconnect this product from power.
2. Using a Phillips #2 head screwdriver, unscrew the fuse holder cap from the housing.
3. Remove the blown fuse.
4. Replace with a good fuse of the same type and rating.
5. Screw the fuse holder cap back in place and reconnect power.
Always replace a blown fuse of the same type and rating.
chart. The listed current rating indicates
Page 7 of 14