Reboot; Reset Config - D-Link DGS-1210-10 Reference Manual

5 Command Line Interface
Syntax
Description
Parameters
Restrictions
Example usage:
To display the contents of the IP routing table:
DGS-1210-28> show iproute
Command: show iproute
Routing Table
IP Address/Netmask Gateway
---------------------------- ---------------
Total Entries :0
DGS-1210-28>

reboot

Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To restart the Switch:
DGS-1210-28> reboot
% Device will reboot, please wait a few minutes to re-login.
DGS-1210-28>

reset config

Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To restore all of the Switch's parameters to their default values:
show iproute {<ipaddr> | static}
The show iproute command will display the Switch's current IP
routing table.
<ipaddr> - Enter the IP address used here.
static – Specifies to display all the static routes.
None.
Interface
-------------- ---------
To reboot the Switch. If the Switch is a member of a stack, it may
be rebooted individually, without affecting the other members of
the stack.
reboot
The reboot command reboots the system. All network
connections are terminated and the boot code executes.
None.
None.
To reset the Switch to the factory default settings.
reset config
All configurations will be reset to the default settings.
None.
None.
9 9 9 9
D-Link Web Smart Switch User Manual
Hops Protocol
---------------