Choosing Movement Direction; Current Sensor Adjustment - Chamberlain MIRACLE-1 Elite Series Installation Instructions Manual

CHOOSING MOVEMENT DIRECTION

Switch the "Open Inside / Open Outside" switch on the control board to the
OPEN INSIDE
OR
OPEN
INSIDE
NO
OFF

CURRENT SENSOR ADJUSTMENT

OPTION - Stop by POS - STOP
This option is to be turned to yes if the gate will
use positive stops at the close position.
IMPORTANT:
It is necessary to still adjust your
limit switch at the close position. The controller
will look for the limit close first and then it will
look for the positive stop.
12
corresponding position for the proper direction.
OPEN
OUTSIDE
YES
ON
60
Sensor Adjustment
OR
OPEN OPEN
INSIDE OUTSIDE
NO YES
OFF ON
60
OPEN OUTSIDE
The sensors must be adjusted while the
gate is in the opening or closing cycle.
Set the sensor adjustment
so when the gate hits any
object while opening, it will
stop and when the gate hits
any object while closing, it
will reverse.
vate the operator and the
gate stops in the middle of
the driveway, the sensor is
set too sensitive.
Stop by
Positive
Stop Option
Note: If you acti-