Table of Contents
Advertisement
Frequently-Asked Questions
This section describes problems that you may encounter while using the SE-700. If you have questions, please refer
to related sections and follow all the suggested solutions. If problem still exists, please contact your distributor or
the service center.
No.
Problems
1.
In the Still option, images are sometimes
distorted if they are captured from live video
fed into Inputs 1-4.
2.
Is CUT transition available for DSK function?
3.
What are the expected behaviors of
PIP/LUMA/DSK buttons?
4.
Why can't image captured using the Freeze
function be found after the SE-700 is
restarted?
5.
Can PIP/KEYER/DSK be enabled at the same
time?
6.
720p Video output on HDMI-1 cannot be
displayed on TLM-700HD.
7.
Parameter scroll is only one-direction, i.e.
once the end of the list is reached, the user
should reverse the direction of the scroll to go
back to another end of the list.
8.
Is there any indication of PIP/Keyer/DSK
enable?
9.
The user is prompted of the warning of
insufficient volume capacity while updating
firmware on WIN8 Operating System.
Solutions
It is recommended to use still images in the Still option.
DSK function does not support CUT transition in the
current firmware version.
PIP PVW/Keyer PVW/DSK PVW Button ON: Effect
displayed on PVW Screen; after configuring parameters
of PIP/Keyer/DSK, enable PIP PGM/Keyer PGM/DSK
PGM to switch PIP/Keyer/DSK to PGM Screen (or the
user can use CUT or T-Bar to perform transition; CUT is
not available for DSK though).
If only PIP PGM/Keyer PGM/DSK PGM are enabled,
then the effect is displayed on both PVW and PGM
screens.
Image captured using the Freeze function will be lost
after power is switched off. However, you can save it as
a still image if you want to keep it.
Yes, PIP/KEYER/DSK can be enabled at the same time
with PIP at the bottom most layer, Keyer in the middle
and DSK on the topmost layer.
Please use TLM-170H/170P/434H for such application.
Some of the parameters allow the user to cycle through
the available values, whereas other parameters allow
only one direction scroll.
There are two indications of PIP/Keyer/DSK enable:
1. There are tally indications for channels set to key and
fill sources of PIP/Keyer/DSK.
2. Borders of screens of the multiscreen assigned to
PIP/Keyer/DSK will be lit with a color. Also, the
PIP/Keyer/DSK button will be lit.
In the case of upgrading the keyboard firmware, the
user should delete the original firmware file first before
copying the new firmware file to the device.
26
Advertisement
Table of Contents
