Position The Opener - Chamberlain FS2 Security+ Owner's Manual

INSTALLATION STEP 4

Position the Opener

Follow instructions which apply to your door type as illustrated.
SECTIONAL DOOR OR ONE-PIECE DOOR WITH TRACK
A 38 mm board is convenient for setting an ideal door-to-rail
distance.
• Raise the opener onto a stepladder. You will need help at this
point if the ladder is not tall enough.
• Open the door all the way and place a 38 mm board on the top
section beneath the rail.
• If the top section or panel hits the trolley when you raise
the door, pull down on the trolley release arm to disconnect
inner and outer sections. Slide the outer trolley toward the
motor unit. The trolley can remain disconnected until
Installation Step 11 is completed.
ENGAGED
ONE-PIECE DOOR WITHOUT TRACK
• With the door fully open and parallel to the floor, measure the
distance from the floor to the top of the door.
• Using a stepladder as a support, raise the top of the opener to
this height.
• The top of the door should be level with the top of the motor
unit. Do not position the opener more than 5 cm above this
point.
Trolley
Release Arm
RELEASED
To prevent damage to garage door, rest garage door opener
rail on 38 mm board placed on top section of door.
Rail
Door
20
a 38 mm board is used to determine
the correct mounting height from
ceiling.
Header
Bracket
Top of Door
a 38 mm board is used to determine
the correct mounting height from
ceiling.