Use Browser-Based Access To Set Up Broadcast Filtering - NETGEAR ProSAFE GSS108E User Manual

You are asked to enter the password for the switch.
5. Enter the switch's password in the password field.
The switch's default password is password.
The Switch Status screen displays.
6. Select QoS > Broadcast Filtering.
The Broadcast Filtering screen displays.
7. Select the Enable radio button.
If the selected switch supports configuring individual ports, a Storm Control Rate screen
displays. If the selected switch does not support individual port configuration, all the ports
are set to a predetermined storm control rate.
8. If the ports can be configured, complete the fields to specify the rate.
9. Click the APPLY button.
Your settings are saved.

Use Browser-Based Access to Set Up Broadcast Filtering


To set up broadcast filtering:
1. Set up your computer to use an IP address in the same subnet as the IP address of the
switch.
2. Use an Ethernet cable to connect your computer to an Ethernet port on the switch.
3. Launch a web browser.
4. In the address field of the browser, enter the IP address of the switch.
You can find the IP address of the switch by using the ProSAFE Plus utility or get it from
the DHCP server. If the switch cannot get an IP address from a DHCP server, enter
192.168.0.239.
You are asked to enter the password for the switch.
5. Enter the switch's password in the password field.
The switch's default password is password.
The Switch Information screen displays.
6. Select QoS > Broadcast Filtering.
The Broadcast Filtering screen displays.
ProSAFE 8-Port and 16-Port Gigabit Click Switch
Optimize Performance with Quality of Service
36