NETGEAR GSS108E Installation Manual

Installation Guide
8-Port and 16-Port Gigabit Ethernet
Smart Managed Plus Click Switch
Model GSS108E and GSS116E

Package Contents

Click switch
Cable retention
straps (2)
Bracket with wall-mount screw kit
Ethernet cables not included.

1. Register with the NETGEAR Insight App

Use the NETGEAR Insight app to register your switch, activate your warranty, and
access support.
1. On your iOS or Android mobile device or tablet, visit the app store, search
for NETGEAR Insight, and download the latest version of the app.
2. Open the NETGEAR Insight app.
3. If you did not set up a NETGEAR account, tap Create NETGEAR Account and
follow the onscreen instructions.
4. Enter the email address and password for your account and tap LOG IN.
5. Tap + in the upper right corner.
6. Enter the serial number located on the bottom of the switch, or use the
camera on your mobile device or tablet to scan the serial number bar code.
7. Tap Go.
8. Follow the onscreen instructions to add your switch to a network location.
The switch is registered and added to your account.

2. Mount the Switch

Peel the plastic cover off the adhesive squares on the rear of the bracket. This
helps hold the bracket in place during mounting.
Wall Mount the Switch
Power cord
(varies by region)
1
Drywall
mount
screw kit
OR
Wall mount to Drywall
a stud (or solid mount
surface)
Strap Mount the Switch
1
Note: For more information about mounting, see the hardware installation guide
which you can download from https://www.netgear.com/support/.
3
Note: For drywall, use
the plastic anchors
and fold the wings in
2
before inserting an
anchor into a wall.
3
2