NETGEAR GSS108EPP Installation Manual

Installation Guide

8-Port Gigabit Ethernet
Smart Managed Plus Click Switch
Model GSS108EPP

Package Contents

• Click switch
• Power cord (varies by region)
• Cable retention straps (2)
• Bracket with wall mount screw kit
• Drywall mount screw kit
Ethernet cables not included.
1. Register with the NETGEAR Insight App
Use the NETGEAR Insight app to register your switch, activate your warranty, and
access support.
1. On your iOS or Android mobile device or tablet, visit the app store, search
for NETGEAR Insight, and download the latest version of the app.
2. Open the NETGEAR Insight app.
3. If you did not set up a NETGEAR account, tap Create NETGEAR Account and
follow the onscreen instructions.
4. Enter the email address and password for your account and tap LOG IN.
If your mobile device is connected with WiFi to the same network as the
switch, the switch displays in the list of Insight Manageable Devices.
5. Either tap the switch in the list, or tap + in the upper right corner.
If you tapped +, enter the serial number on the bottom of the switch, or scan
the serial number bar code with the camera on your mobile device or tablet.
Then tap Go.
6. Follow the onscreen instructions to add your switch to a network location.
The switch is registered and added to your account.

2. Mount the Switch

Peel the plastic cover off the adhesive squares on the rear of the bracket. This
helps hold the bracket in place during mounting.
Wall Mount the Switch
1
OR
Note: For drywall, use
the plastic anchors
and fold the wings in
before inserting an
anchor into a wall.
Wall mount to Drywall
a stud (or solid mount
surface)
Strap Mount the Switch
3
1
2
Note: For more information about mounting, see the hardware installation guide
which you can download from https://www.netgear.com/support/.
3
2