Use Browser-Based Access To Enable 802.1P-Based Qos; Enable Port-Based Quality Of Service - NETGEAR ProSAFE GSS108E User Manual

Use Browser-Based Access to Enable 802.1p-Based QoS

This feature is enabled by default.

To disable or enable 802.1p-based QoS:
1. Set up your computer to use an IP address in the same subnet as the IP address of the
switch.
2. Use an Ethernet cable to connect your computer to an Ethernet port on the switch.
3. Launch a web browser.
4. In the address field of the browser, enter the IP address of the switch.
You can find the IP address of the switch by using the ProSAFE Plus utility or get it from
the DHCP server. If the switch cannot get an IP address from a DHCP server, enter
192.168.0.239.
You are asked to enter the password for the switch.
5. Enter the switch's password in the password field.
The switch's default password is password.
The Switch Information screen displays.
6. Select QoS.
7. Select or clear the 802.1p/DSCP Based radio button.
8. Click the Apply button.
Your settings are saved.

Enable Port-Based Quality of Service

You can assign a priority to all data passing through a particular port. A higher priority
transmits data faster. If packets arrive at several ports at the same time, the ports configured
as higher priority transmit their packets first. You must determine which ports will carry
delay-sensitive data.
ProSAFE 8-Port and 16-Port Gigabit Click Switch
Optimize Performance with Quality of Service
31