Each port on the GS104 switch automatically configures itself correctly when you plug in a device’s cable. If you have a problem with your switch, NETGEAR offers free support 24 hours a day and 7 days a week on the Web (www.NETGEAR.com), by e-mail (support@NETGEAR.com) and by phone (see the provided support information card for phone numbers).
Page 4
If you don’t have everything listed above, see the support information card for contact infor- mation. If you’re missing the support information card itself, get contact information at www.NETGEAR.com in the Customer Service area Model GS104 4-Port 10/100/1000 Mbps Gigabit Ethernet Switch...
Prepare to Install the Switch Decide where you want to place the switch. Find a flat horizontal surface — such as a table, desk or shelf. The switch comes with wall-mounting screws. You’re welcome to use the screws if you want to hang the switch in an open space on a wall.
Ethernet ports on the switch. 3. Connect the power adapter’s cord into the back of the switch and then plug the adapter into a power source (such as a wall socket or power strip).
• Make sure you are using the NETGEAR power adapter supplied with your switch. The Port number light is not lit for a connected device or stays on continuously There’s a hardware connection problem.
In the interest of improving internal design, operational function, and/or reliability, NETGEAR reserves the right to make changes to the product described in this document without notice. NETGEAR does not assume any liability that may occur due to the use or application of the product(s) or circuit layout(s) described herein.