Cpu Fan Connector - DFI 586ITXD User Manual

CPU Fan Connector

The system board is equipped with a 3-pin fan connector at
location JP2 of the system board. Connect the processor' s fan cable
connector to JP2.
ATX Connector
The system board is equipped with an ATX power connector at
location J4 of the system board. Using an ATX power supply, you
can either shut down your computer by pressing the Power button
located on the front bezel of your computer or by executing the
Shut Down command under the Windows
Your system will enter the " soft power off" state.
To power on your system automatically, enable " Resume By Alarm"
in the Power Management Setup of the Award BIOS. This will allow
you to set the date and time you would like your system to wake
up.
Install the 20-pin ATX power cable connector into location J4 on the
system board. The 20-pin connector can be inserted into J4 only if
pin 1 of the connector is aligned with pin 1 of J4.
Connecting Cables
Pin Function
1 Fan
2 +12V
3 Fan speed
sensor
®
95 operating system.
69
B