Cpu Fan Connector - DFI 586ITBD User Manual

CPU Fan Connector

The 586ITBD system board is equipped with a 3-pin fan connector
at location JP5 of the system board.
Power Supply Connectors
The 586ITBD is a Baby AT form factor system board designed to fit
into an ATX form factor chassis. The board is equipped with both
ATX (J11) and AT (J1) power supply connectors.
" Power-Supply Type" in the Chipset Features Setup must be set
according to the type of power supply installed in your computer.
The default is AT (for an AT power supply). If you are using an ATX
power supply, make sure to set this field to ATX. Refer to Chapter
3 - Chipset Features Setup for more information.
Using an ATX power supply, you can either shut down your com-
puter by pressing the Power button located on the front bezel of
your computer or by executing the Shut Down command under
the Windows 95 operating system. Your system will then enter the
" Soft Off" state.
To power on your system automatically, enable " Resume By Alarm"
in the Power Management Setup of the Award BIOS. This will allow
you to set the day and time you would like your system to wake
up. Refer to Chapter 3 - Power Management Setup for more
information.
Hardware Installation
Pin Function
1 GND
2 +12V
3 NC
41
2