Main Broom Replacement - Alto FLOORTEC R 570 P User Manual

MAIN BROOM REPLACEMENT

NOTE
Brooms with harder or softer bristles are
available. This procedure is applicable to all types
of brooms.
CAUTION!
It is advisable to wear protective gloves when
replacing the main broom because there can
be sharp debris between the bristles.
1. Drive the machine on a level ground and engage the
parking brake with the pedal (3) and the lever (4).
2. Turn the ignition key (82) to "0".
3. Unscrew the knobs (23) and remove the right door (22).
4. Loosen the knob (A, Fig. 3).
5. Unscrew the knobs (B, Fig. 3) and remove the broom
compartment cover (C).
6. Remove the broom (A, Fig. 4).
7. Check that the drive hub (A, Fig. 5) is free from dirt or
foreign materials (ropes, rags, etc.) accidentally rolled up.
8. The new main broom must be installed with the bristles
rows (B, Fig. 5) bent as shown in the fi gure.
9. Install the new main broom (C, Fig. 5) and ensure that the
mesh (D) correctly fi ts into the relevant drive hub (A).
10. Install the broom compartment cover (C, Fig. 3) and screw
the knobs (B) and (A).
11. Install the right door (22), then screw the knobs (23).
12. Check and adjust the main broom height as shown in the
previous paragraph.
146 2727 000(2)2007-02 A
USER MANUAL
A
C
B
Figure 3
Figure 4
Figure 5
FLOORTEC R 570 P
ENGLISH
B
S311391
S311392
S311393
19