Alto FLOORTEC R 570 P User Manual page 60

ENGLISH
– Carefully read all the instructions before performing any maintenance/repair procedure.
– Take all necessary precautions to prevent hair, jewels and loose clothes from being caught by the machine moving
parts.
– Do not leave the machine unattended with the key inserted in the ignition switch and the parking brake disengaged.
– Do not use the machine on slopes with a gradient exceeding the specifi cations.
– Do not use the machine in excessively dusty areas.
– Do not wash the machine with direct or pressurised water jets, or with corrosive substances. Do not use compressed
air to clean this type of machine, except for the fi lters (see the relevant paragraph).
– While using this machine, take care not to cause damage to other people, and children especially.
– Do not put any can containing fl uids on the machine.
– The machine storage temperature must be between 0°C and +40°C.
– The machine working temperature must be between 0°C and +40°C.
– The humidity must be between 30% and 95%.
– Always protect the machine against the sun, rain and bad weather, both under operation and inactivity condition.
– Do not use the machine as a means of transport, or for pushing/towing.
Do not allow the brooms to operate while the machine is stationary to avoid damaging the fl oor.
–
– In case of fi re, possibly use a powder fi re extinguisher, not a water one.
– Do not bump into shelves or scaffoldings, especially where there is a risk of falling objects.
– Adjust the operation speed to suit the fl oor conditions.
– Do not use the machine on slopes with a gradient exceeding the specifi cations.
– This machine cannot be used on roads or public streets.
– Do not tamper with the machine safety guards.
– Strictly follow the instructions for the ordinary service operations.
– Do not remove or modify the plates affi xed to the machine.
– In case of machine malfunctions, ensure that these are not due to lack of maintenance. Otherwise, request assistance
from the authorised personnel or from an authorised Service Center.
– If parts must be replaced, require ORIGINAL spare parts from an Authorised Dealer or Retailer.
– To ensure machine proper and safe operation, the scheduled maintenance shown in the relevant chapter of this
Manual must be performed by the authorised personnel or by an authorised Service Center.
– The machine must be disposed of properly, because of the presence of toxic-harmful materials (batteries, oils,
plastics, etc.), which are subject to standards that require disposal in special centres (see the Scrapping chapter).
– If the machine is used according to the instructions, the vibrations are not dangerous. The machine vibration level is
2
below 2.5 m/s (EN 1033-1995-08; EN 1032/A1-1998)
– Carefully read all the instructions before performing any maintenance/repair procedure.
– While the engine is running, the silencer warms up; do not touch the silencer when it is hot to avoid burns or fi res.
– Running the engine with an insuffi cient quantity of oil can seriously damage the engine. Check the oil level with the
engine off and the machine on a level ground.
– Never run the engine if the air fi lter is not installed, because the engine could be damaged.
– Technical service procedures on the engine must be performed by an authorised Dealer.
– Only use original spare parts or parts of matching quality for the engine. Using spare parts of lower quality can
seriously damage the engine.
6
USER MANUAL
FLOORTEC R 570 P
WARNING!
146 2727 000(2)2007-02 A