....1 This manual contains sections of Safety Instructions,Operating Instructions, Installation Instructions and Troubleshooting Tips etc. Carefully reading it before using the dishwasher will help you to use and maintain the dishwasher properly.
Page 3
Under certain conditions, Hydrogen gas may be produced in a hot-water system that has not been used for two weeks or more. HYDROGEN GAS IS EXPLOSIVE. If the hot-water system has not been used for such a period, before using the dishwasher turn on all hot-water faucets and let the water flow from each for several minutes.
To get the best performance from your dishwasher,read all operating instructions before using it for the first time. S TRON G N ORMAL ECON OMY RIN SE RAP I D SO AK START RE SE T O FF 8 ON/OFF Button: To turn on/off the power supply. 1 Pre-rinse light: To come on when Pre-rinse.
Page 5
Pre-wash For the heaviest soiled loads, -wash( 0℃ such as pots,pans,casserole Wash (50 ℃) Strong 4/20 g dishes and dishes that have Rinse been sitting with dried food Rinse (70 ℃) on them for a while. Drying Pre-wash For normally soiled loads, -wash such as pots...
Page 6
If your model have not water softener, you may skip this section. The hardness of the water varies from place to place. If hard water is used in the dishwasher, deposits will form on the dishes and utensils. The appliances is equipped with a special softener that uses a salt specifically designed to eliminate lime and minerals from the water.
The dishwasher is designed to allow for adjusting the amount of salt consumed based on the hardness of the water used. This is intended to optimize and customize the level of salt consumption so that the salt consumption could be set proceed as follows: Unscrew the cap from the salt container.
To open the dispenser, turn the cap to the "open" (left) arrow and lift it out. Pour the rinse aid into the dispenser, being careful not to overfill. Replace the cap by inserting it aligned w ith "open" arrow and turning i t to the closed (right) arrow. The rinse aid is released during the final rinse to prevent water from forming droplets on your dishes that can leave spots and streaks.
Page 9
Scrape off any large amounts of left-over food. It is not necessary to rinse the dishes under running water. Place objects in the dishwasher in following way 1.Items such as cups, glasses, pots/pans, etc. are stood upsi de down. 2.Curve items, or those with recesses, should be at a slant so that water can run off. 3.They are stacked securely and cannot tip over.
We recommend that you place large items which are most difficult to clean into the lower rack: pots, pans, lids, serving dishes and bowls, as shown in the figure to the right. It is preferable to place serving dishes and lids on the side of the racks in order to avoid blocking the rotation of the top spray arm.
Page 11
Silverware should be placed in the silverware basket with handles at the bottom: If the rack has side baskets, the spoon should be loaded individually into the appropriate slots, Especially long utensils should be placed in the horizontal position at the front of the upper rack.
A forgotten dish can be added any time before the detergent cup opens. Please press the start button. Add forgotten dishes. Do not open the door until the water spray action stops. Close the door and Press the Start button to start washing. Steam may rise out of the dishwasher.
Page 13
Filter assembly For best performance and results, the filter assembly must be cleaned. The filter efficiently removes food particles from the wash water, allowing it to be recirculated during the cycle. For this reason, it is a good idea to remove the larger food particles trapped in the filter after each wash cycle by rinsing the semicircular filter and cup under running water.
Page 14
Never run the dishwasher without the filters in place. When cleaning the filters, don't knock on them .Otherwise the filters could be contorted and the performance of dishwasher could be debased. To clean the edge around the door, you should use only a soft warm, damp rag. To prevent penetration of water into the door lock and electrical components, do not use a spray cleaner of any kind.
Page 15
Connect the cold water supply hose to a threaded 3/4(inch) connector and make sure that it is fastened tightly in place. If the water pipes are new or have not been used for an extended period of time, let the water run to make sure that the water is clear and free of impurities.
DIMENSIONS(mm) 1135 Dimension: 450x580x850(mm) Capacity: 8 Place setting ater pressure: 0.04-1.0MPa Power supply: 1930W Rated voltage: 230V/50Hz...
Page 17
Position the appliance in the desired location. The back should rest against the wall behind it, and the sides, along the adjacent cabinets or wall. The dishwasher is equipped with water supply and drain hoses that can be positioned to the right or the left to facilitate proper installation.
Page 18
Fuse blown, or the Replace fuse or reset circuit breaker. Remove any other circuit breaker acted appliances sharing the same circuit with the dishwasher Power supply is not Make sure the dishwasher is turned on and the door is turned on closed securely.
Page 19
Combination of soft Use less detergent if you have soft water and select a water and too much shortest cycle to wash the glassware and to get them clean. detergent Tea or coffee stains using a solution of 1/2 cup of bleach and 3 cups warm water to remove the stains by hand.
Page 20
DSG Retail Limited is responsible for after sales service and any claims in respect of this licensed product. If you have a query about the product please contact our Currys product support line (08701) 565550 Partmaster .co.uk Visit Partmaster.co.uk today for the easiest way to buy electrical spares and accessories. With over 1 million spares and accessories available we can deliver direct to your door the very next day.
Need help?
Do you have a question about the MS452S and is the answer not in the manual?
Questions and answers