4-6.Electrical Connection - Proline DWF1250P Service Manual

Service Manual
Model :DWF1250P/DWP5012WA/DWP4912W/DWP4915SL
Attention:
The connecting piece for syphon trap (U-bend) must be solidly fastened to the wall to
prevent the drain hose from moving and allowing water to spill outside the drain.

4-6.Electrical Connection

After making sure that the voltage and frequency values for the current in the home correspond to
those on the rating plate (located on the stainless steel inner door of the appliance) and that the
electrical system is correct for the maximum voltage on the rating plate, insert the plug into an
electrical socket which is earthed properly (the earthing of the appliance is a safety requirement
mandated by law).If the electrical socket to which the appliance must be connected is not
appropriate for the plug, replace the whole cable, rather than using adaptors or the like as they
could cause overheating and burns.
Caution:
The dishwasher plug must be accessible even when the appliance is installed as a
built-in unit so that maintenance can be done safely.
Electrical Connection (Uk Only)
For your safety please read the following information.
Warning: This appliance must be earthed.
The appliance must be connected to a 220-240 volts 50 cycle AC supply by means of a three pin
socket, suitably earthed and should be protected by a 13 amp fuse in the plug.
The appliance is supplied with a rewireable 13 amp 3-pin plug fitted with a 13-amp fuse. Should
the fuse require replacement, it must be replaced with a fuse rated at 13 amp and approved to
BS1362.
If the mains plug is unsuitable for the socket outlet in your home or is removed for any other
reason,then the cut off plug should be disposed of safely to prevent the hazard of electric shock.
Remove the fuse before disposal.
There is a danger of electric shock if the cut off plug is inserted into any 13-amp socket outlet.
fig.C
8
Issue
Rev.