Section 8: Removing The Door - Montigo H38DF-CLCR Installation & Maintenance Manual

Section 8: Removing the Door

WARNING
When reinstalling door(s), always make sure all door
buckles are properly hooked and fully engaged.
Removing the Front door:
The H*38C* Front door is removed in a few simple steps. Follow these
below to remove the Horizontal access panel, unlatch the door buckles
and, remove the door. Replace in reverse order. The smaller Side door
is bolted in place.
Remove the Horizontal Access Panel:
Step 1:
Remove the Horizontal cover
by placing fingers in both finger
holes, then pushing away from
you and lifting out. Place it
aside during maintenance or
cleaning.
Install in reverse order.
Figure 24� Removing and installing the Horizontal Access Panel
Step 2:
Locate the Door Buckles:
Door buckles
Figure 24a. Locate the door buckles.
Step 3:
Release the Door Buckles
Hand-hold
Figure 24b. Door buckle Tool
XG0213 - 150204.2
Installation
Finger Holes
Installed Gas
Valve Cove r
Small glass door
affixed to frame
with hardware.
Door Latch Slot
Door Latch Hook
Step 4:
Firmly grasp hand-hold
end of Door buckle tool
and place the machined
end in the slot under door
frame. (as shown)
Figure 24c�
Step 5:
Ensure the tool is firmly
in the lower end of the
slot, (as shown), Then pull
toward you (Caution: hold
the tool securely).
Figure 24d�
Step 6:
Pull hard if necessary to
release the spring ten-
sion. (Caution: The latch
springs back with force,
hold the tool securely).
Figure 24e�
Step 7:
Remove the tool from
the latch slot. Ensure the
latches are hanging freely,
the hook end is released
from the bottom of the door.
(Repeat all 4-steps for the
remaining latches).
Figure 24f�
H*38DF-CLCR Corner Gas Fireplace
1
2
3
4
Page 23