Installing And Removing The Door; Section 7: Installing And Removing The Door - Montigo L38DF-ST series Installation & Maintenance Manual

L38DF-ST* Indoor Gas Fireplace
Section 7:
Installing & Removing the Door
Removing the door:
The L38DF-ST* doors are removed in a few simple steps. Follow these
below to remove the Horizontal access panel, unlatch the door buckles
and, remove the door. Replace in reverse order.
Remove the Horizontal Access Panel:
Remove the Horizontal Access Pan
Step 1:
Remove the Horizontal cover
by placing fingers in both finger
holes, then pushing away from
you and lifting out. Place it
aside during maintenance or
cleaning.
Install in reverse order.
Figure 26. Removing and installing the the Horizontal Acess Panel
Locate the Door Buckles:
Step 2:
Figure 26a. Locate the door buckles. (Both Sides Typical)
Release the Door Buckles
Step 3:
Hand-hold
Figure 26b. Door buckle Tool
Step 4:
Firmly grasp hand-hold
end of Door buckle tool
and place the machined
end in the slot under door
frame. (as shown)
Figure 26c.
Page 18
Installation
Installation
Finger Holes
Installed Gas
Valve Cove r
Door Latch Slot
Door Latch Hook
1
Step 5:
Ensure the tool is firmly
in the lower end of the
slot, (as shown), Then pull
toward you (Caution: hold
el:
the tool securely).
Figure 26d.
Step 6:
Pull hard if necessary to
release the spring ten-
sion. (Caution: The latch
springs back with force,
hold the tool securely).
Figure 26e.
Step 7:
Remove the tool from
the latch slot. Ensure the
latches are hanging freely,
the hook end is released
from the bottom of the door.
(Repeat all 4-steps for the
remaining latches).
Figure 26f.
Step 8:
Grasp the Door on either side, usually midway and lift upward, lift
the door carefully up and away from the front of the fireplace. See
Figures 26g. Place the Door aside in a safe place while maintenance
and / or cleaning is being performed.
Figure 26g. Removing and installing the glass doors. (Both Sides
Typical)
To install the door, hook the top edge of the door frame into place. Lower
the door into position and follow the previous steps shown in reverse order.
lower and rest the door frame in place and fasten the buckles. See
figures 28a and 28b.
4
Removing the Door:
Installing the Door:
2
3
Part No. XG0810 - 081310-1