Table of Contents
Advertisement
Chassis Setup and Maintenance
5-1
Overview
This chapter covers the steps required to install components and perform main-
tenance on the chassis. Most components of the SC721 do not require tools or
screws to set them up. Those components which must be secured with screws
require only a Phillips screwdriver.
5-2
Removing Power from the System
Before performing some setup or maintenance tasks, use the following procedure
to ensure that power has been removed from the system.
1. Use the operating system to power down the system, following the on-screen
prompts.
2. After the system has completely shut-down, carefully grasp the head of the
power cord and gently pull it out of the back of the power supply. If your sys-
tem has dual power supplies, remove the cords from both power supplies.
3. Disconnect the cord from the power strip or wall outlet.
Chapter 5: Chassis Setup and Maintenance
Chapter 5
5-1
Advertisement
Table of Contents
