Viking VS 3725 Installation Manual page 11

2 STEP DOOR UNLOCK WIRE CONNECTION FOR
GROUND SWITCHED DOOR LOCKS
14-Pin
Plug
Pink Wire
From
Alarm
Existing Neg.
Unlock Wire
Green Wire
Door Lock
87
3 Pin
Blue Wire
Plug
Door Unlock
86
To
Alarm 87A
30
OEM
Door Lock
Motor
Cut Existing Unlock
A. PROGRAMMING THE REMOTE TRANSMITTER:
Note: This mode will only retain the last 4 remote transmitters programmed. If the transmitter memory is
exceeded, the security system will start deleting transmitters from memory in chronological order.
1. Turn the Ignition 'switch 'OFF/ON' 3 TIMES and stay in ON position.
2. Within 15 seconds. push the Valet switch 3 times and holding in on 3rd push until a long chirp is
hearing then release the valet switch. You are now in the Transmitter programming mode.
3. Press and hold any button of the transmitter until the siren responds with a confirming chirp, indicating
the signal has been stored into memory.
4. If you have additional transmitters (up to 4) that need to be programmed, repeat step 3 for each
transmitter.
Exit: Turn Ignition to 'OFF' position, or leave it for 15 seconds. A 3 long chirps & 3 parking light flashes to
confirm exit.
B. ALARM FEATURE PRORAMMING:
1. Turn the Ignition switch 'ON then Off 3 TIMES and stay in Off position.
2. Within 10 seconds, push and release the Valet switch 4 times and holding in on the 4
long chirp from siren to confirm you are now in the Alarm feature-programming mode.
Press
Press and One Chirp /
release LED one pulse
Valet Factory Default
Switch
Setting
One time All chirps on
Two times Active arming
Three times 0.8-second Door
lock pulses.
Four times Ignition controlled
door locks &
unlocks
Five times Instantly Door Ajar
Warning
Six times Automatic Rearm
on
Seven Override Without
times Password Pin Code
VS3725IN
OEM Door Master Lock Switch
Unlock Lock
Existing Neg.
Lock Wire
85
OEM Door
Lock Relay
+ 12V
X
To All Other
Door Lock
Motors
PROGRAMMING
button Press
Two Chirps /
LED two pulses
Siren chirp on only
Passive arming
without passive door
locking
3.5-second Door lock
pulse.
Ignition controlled
door locks only
45 seconds delay
Door Ajar Warning.
Automatic Rearm off
Override With
Password Pin Code
2 STEP DOOR UNLOCK WIRE CONNECTION FOR
POSITIVE SWITCHED DOOR LOCKS
+12V
14-Pin
87
Plug
From Pink Wire
Alarm
86 87A
30
Blue Wire Door Lock
3 Pin Green Wire
87
Plug Door Unlock
To
86
Alarm
30
OEM Driver's
Door Lock
Motor
Cut Existing Unlock
button Press
Three Chirps /
LED three pulses
Horn chirp on only
Passive arming
with passive door
locking.
Double pulse
unlock
Ignition controlled
door unlocks only
11
FEBERARY/06/2006
OEM Door Master Lock Switch
Unlock
85
Existing Pos.
Unlock Wire
+ 12V
Existing Pos.
Lock Wire
+ 12V
87A
85
OEM Door
Lock Relay
X
th
push until one
button Press button
Four Chirps /
LED four pulses
All chirps off
Door lock with
"Comfort Feature"
Without ignition
controlled door
locks & unlocks
Lock
To All Other
Door Lock
Motors