Schedule - Planet Networking & Communication ICA-5260V User Manual

Record Time Setting
Tampering Detection
Face Detection
Digital Image Stabilizer
Network Disconnected
Network IP Check

5.4.2 Schedule

Schedule
Snapshot
Interval
Pre Alarm and Post Alarm setups for video start and end time when
motion detects I/O, or other devices got triggered.
Note: Pre/Post Alarm record time is based on record time setting and
IP cam built-in RAM memory. Limited by IP cam built-in Ram memory
and when information is too much or video quality is set too high, it
will cause recording frame to drop or decrease post alarm recording
time.
If user enables this function and when the camera view is covered,
moved, shot by strong light, or out of focus, the tampering detection
will be triggered, and send snapshot to mail/FTP/Samba/SD card, or
trigger the external alarm.
If user enables this function, the action selected will be triggered
when a face is detected.
The digital image stabilizer reduces shaking images.The most
important situation is when there is not enough light to get a fast
shutter speed.
To avoid video loss, the camera will start to save the video to
local SD card when it detects no network connection. The video
recording will continuously be saved onto SD card and divided into
every 10 minutes a file until the network is reconnected successfully.
The oldest file will be deleted if the capacity of SD card is full.
Key- in the target IP address and interval. The camera checks once
in a while according to the setting interval time if it can link to the
target IP address. If connection fails, the camera starts to save the
video to SD card
After completing the scheduled setup, the camera data will be
recorded according to the scheduled setup.
After enabling the snapshot function, user can select the storage
position of snapshot file, the interval time of snapshot and the
reserved file name of snapshot.
The interval between two snapshots.
59
60fps Full HD Vandalproof IR IP camera
ICA-5260V