Important Safety Information; Insert Certifi Cation; Btu & Effi Ciency Specifi Cations; Mobile Home Approved - Quadra-Fire 5100 ACC Installation Manual

1

Important Safety Information

A. Insert Certifi cation
Model: 5100-I (ACC) Insert
Laboratory: Intertek
Report No: 100323198PRT-001a
Type: Solid Fuel Type, Listed Room Heater
Standard: UL1482 and ULC S628-93 and
(UM) 84-HUD, Mobile Home
Approved.
NOTE: This installation must conform with local codes. In the
absence of local codes you must comply with the UL1482, (UM)
84-HUD and NPFA211 in the U.S.A. and the ULC S628-93 and
CAN/CSA-B365 Installation Codes in Canada.
B. BTU & Effi ciency Specifi cations
EPA Certifi ed:
Effi ciency:
EPA BTU Output:
Heating Capacity:
Vent Size:
Firebox Size:
Max Wood Length:
Max First Hour BTUs:
Fuel:
Shipping Weight:
The Quadra-Fire 5100 Wood Insert (ACC) meets the U.S. Environ-
mental Protection Agency's 1990 particulate emission standards.
C. Mobile Home Approved
• This appliance is approved for mobile home installa-
tions when not installed in a sleeping room and when
an outside combustion air inlet is provided.
• The structural integrity of the mobile home fl oor, ceil-
ing, and walls must be maintained.
• The appliance must be properly grounded to the frame
of the mobile home with #8 copper ground wire, and
chimney must be listed to UL103 HT or a listed UL-
1777 full length six inch (152mm) diameter liner must
be used.
• Outside Air Kit, part OAK-ACC must be installed in a
mobile home installation.
D. Glass Specifi cations
This stove is equipped with 5mm ceramic glass. Replace
glass only with 5mm ceramic glass. Please contact your
dealer for replacement glass.
Quadra-Fire is a registered trademark of Hearth & Home
Technologies.
August 25, 2014
4.17 grams per hour
up to 80.5%
10,500 to 27,900
2,250 to 3,175 sq ft depending
on climate zone
6 inches
3 cubic feet
22 inches
73,200 @ 75.5% B415 Tested
Effi ciency
Cord Wood
480 lbs
Fire Risk.
Hearth & Home Technologies disclaims any
responsibility for, and the warranty will be voided by,
the following actions:
• Installation and use of any damaged appliance.
• Modifi cation of the appliance.
• Installation other than as instructed by Hearth & Home
Technologies.
• Installation and/or use of any component part not approved by
Hearth & Home Technologies.
• Operating appliance without fully assembling all components.
• Operating appliance without legs attached (if supplied with unit).
• Do NOT Overfi re - If appliance or chimney connector glows,
you are overfi ring.
Any such action that may cause a fi re hazard.
Improper installation, adjustment, alteration, service or
maintenance can cause injury or property damage.
For assistance or additional information, consult a qualifi ed
installer, service agency or your dealer.
NOTE: Hearth & Home Technologies, manufacturer of
this appliance, reserves the right to alter its products, their
specifi cations and/or price without notice.
Hearth & Home Technologies WILL NOT warranty stoves
that exhibit evidence of over-fi ring. Evidence of over-fi ring
includes, but is not limited to:
• Warped air tube
• Deteriorated refractory brick retainers
• Deteriorated baffl e and other interior components
E. Non-Combustible Materials
Material which will not ignite and burn, composed of any
combination of the following:
- Steel
- Brick
- Concrete
- Glass
Materials reported as passing ASTM E 136, Standard
Test Method for Behavior of Metals, in a Vertical Tube
Furnace of 750° C.
F. Combustible Materials
Material made of/or surfaced with any of the following ma-
terials:
- Wood
- Plant Fibers
- Plywood/OSB
Any material that can ignite and burn: fl ame proofed or not,
plastered or un-plastered.
7047-910C
5100 I-ACC
WARNING
- Plaster
- Iron
- Tile
- Slate
- Compressed Paper
- Plastic
- Sheet Rock (drywall)
3