Changing/Replacing Sandpaper Disc - Grizzly G0787 Owner's Manual

Changing/Replacing
Sandpaper Disc
The Model G0787 Disc/Belt Sander accepts 6"
diameter cloth- or paper-backed pressure sensi-
tive adhesive (PSA) sandpaper discs. These are
available in a variety of grits through the Grizzly
catalog. See Accessories on Page 23 for prices
and ordering information.
The PSA sandpaper discs stick directly to the
surface of the aluminum disc.
Removing Sandpaper Disc
1. DISCONNECT MACHINE FROM POWER!
2. Remove work table.
3. Remove (2) M4.2 x 10 tap screws and disc
cover shown in Figure 23.
x 2
Figure 23. Removing disc cover.
4.
Remove old sandpaper disc from aluminum
disc.
Model G0787 (Mfd. Since 09/14)
Attaching Sandpaper Disc
1.
2.
3.
4.
5.
Disc Cover
6.
Peel back protective layer from one-half
of new sandpaper disc and fold it against
remaining half.
Center sticky half of sandpaper disc on upper
half of aluminum disc and press sandpaper
disc onto surface (see Figure 24).
Figure 24. Installing sanding disc.
Remove remaining half of protective layer
from sandpaper disc, then press remaining
portion of sandpaper disc onto aluminum
disc.
Rotate disc by hand and check to make sure
sandpaper is firmly attached to disc without
any bumps or wrinkles.
Re-install disc cover and work table.
Check work table alignment and adjust if
necessary (see Aligning Work Table on
Page 28).
-21-