Figure 2.6.3.2: App - Wi-Fi Settings; Figure 2.6.4.1: Controller Preflight Update; Figure 2.6.4.2: App - Software Update; Figure 2.6.4.3: App - Connect Instructions - 3DR Solo User Manual

In the Solo menu, select Wi-Fi Settings, and set a new password. The password should be between 8 and 32
characters with no spaces. Select Apply to enable your changes. If you forget your SoloLink password, perform the
factory reset procedure in Section 9.7 to reset the password to the temporary password (sololink).
2.6.4 Update
Before your first flight, use the App to perform the required first-flight update of Solo and the Controller. The
Controller will prompt you for the update with the preflight update alert. Ensure that both the Controller and Solo
are powered, the controller has at least 50% battery remaining, and the app is connected to Solo Wi-Fi. The total
update process can take up to 10 minutes.
To start the update, open the Settings menu in the App, and select Software Update.
Because your mobile device has never connected to this Solo before, you will need to link your device with Solo
Wi-Fi (SoloLink). Select Connect Instructions for steps on how to connect.

Figure 2.6.3.2: App - Wi-Fi Settings

ARTOO UPDATE SCREEN FEEDBACK V10C
preflight update
Required before first flight!
Use 3DR Solo App to update
Figure 2.6.4.1: Controller Preflight Update Prompt
Controller updating
Update will take about 5 minutes
Please ensure charger is connected
Controller may go dark while updating
Controller updated
Please reconnect to Sololink wifi

Figure 2.6.4.2: App - Software Update

Press to continue
waiting for Solo
Press when LEDs are green

Figure 2.6.4.3: App - Connect Instructions

Update Requirement Screen
Controller update in progress screen
Is displayed after user initiates update in app.
Persists until controller update is successful.
Update complete feedback.
Tells the user that controller update was successful.
HAPTIC: Three 20 millisecond pulses,
to communicate update completion.
A-Press required to dimiss (same as current implementation)
Waiting for Solo
Persists until Solo reconnects
or
Artoo auto-shutdown
Update complete (Connects to matching version Solo)
12
FLY
Hold to start motors
FLY
Cable Cam
Returns user to hold-Fly-button screen
Update Timeout
If update does not
"update-unsucces
Update failure
If update fails, disp
screen
Update unsuccessful (
update
12 Please us
the
Orbit
Prompt stays on screen