Factory Reset - 3DR Solo User Manual

9.6.2 Controller
As part of the reset procedure, Solo will be un-paired from the controller. Start by powering off Solo. Use a paper
clip or similar tool to press and hold Solo's pair button (Figure 8.3.2.1) while powering on Solo. Release the pair
button after you see the internal LED adjacent to the Pair button start rapidly flashing orange. This signals the
factory reset procedure is now underway.
After a few minutes, Solo's main LEDs will start flashing different colors in a rotating pattern as the reset nears
completion. Once Solo emits an initialization tone, the factory reset is complete, and Solo is now ready to be paired
with the controller; follow the instructions in Section 9.3 to pair Solo with the controller. If the rotating light pattern
stops, but Solo doesn't emit an initialization tone, power off and power on Solo and follow the pairing instructions in
Section 9.3.
48