To Display and Change Temperature Setpoint
Step 1: In "Service Mode" press the "Select" button until "Setpoint" is shown in the water heater display.
Step 2: Press the "Set" button to enter the setting mode. "Setpoint" will flash in the water heater display.
Note: The maximum temperature that can be set in the Water Heater Display is limited to the "Max
Setpoint" described previously. To change the "Max Setpoint", refer to the procedure "To Change the
Maximum Setpoint Limit..." described previously under "Accessing the Service Mode on the Water
Heater Display".
Step 3: To raise the temperature setpoint, press the "Temperature Up" button until the desired temperature is
shown on the water heater display.
idle
Status
SELECT
idle
Status
SELECT
NOTICE
idle
Status
SELECT
setpoint
°F
Operational
SET
"Setpoint" Flashes
setpoint
°F
Operational
SET
"Setpoint" Flashes
setpoint
°F
Operational
SET
47