Bradford White UCG100H199 Installation & Operation Manual page 44

To change the Maximum Setpoint Limit (Max Setpoint) for the temperature setpoint
WARNING
Setting the water temperature to the maximum set point can result in scalding hot water delivered to the
faucets. It is highly recommended that the maximum setpoint be adjusted to the lowest temperature
possible for the needs of the installation. See following section to change the maximum setpoint limit
(max setpoint). Make sure the water heater control display is not in a public area that can result in the
temperature settings being improperly adjusted. See previous warning on scalds and an ASSE approved
mixing valve.
Step 1: In service mode press the "Select" button until "Max Setpoint" is displayed.
Max
°F
Setpoint
idle
Operational
Status

SET
SELECT
Step 2: Press "Set" button to enter setting mode. "Max Setpoint" will flash to indicate setting mode.
"Max Setpoint" Flashes
Max
°F
Setpoint
idle
Operational
Status

SELECT SET
44