Table of Contents
Advertisement
f Prevent hot and cool air from the air conditioning system to blow directly to the ventilation ports (intake and
exhaust) of the projector.
300 mm (11-13/16") or longer
Main unit
300 mm (11-13/16") or longer
Power supply unit
*1 Distance from the wall or ceiling surface which will cover the whole air intake port
*2 Distance from the wall or floor surface which will cover the whole air intake port
f Do not install the projector in a confined space.
When installing the projector in a confined space, provide air conditioning or ventilation separately. Exhaust heat
may accumulate when the ventilation is not enough, triggering the protection circuit of the projector.
Cautions when transporting
f Before transporting, tighten the rotating fixing screw and ball joint fixing screws (2 locations) using the supplied
7/64" Allen wrench. Transporting while they are loose may cause the fingers to be caught in between or
malfunction.
f When the optional Floor Stand Kit is used, hold the bottom of the floor stand attached to the projector, and
handle so that excessive vibration or shock is not applied when transporting. Failure to do so may damage the
internal components and result in malfunctions.
Ball joint fixing screws
Rotating fixing screw
18 - ENGLISH
Chapter 1 Preparation — Precautions for use
Power supply unit
300 mm (11-13/16") or longer
Air intake port
90 mm (3-17/32") or longer
Air exhaust port
90 mm (3-17/32") or longer
Air intake port
300 mm (11-13/16") or longer
200 mm (7-7/8") or longer
*1
200 mm (7-7/8") or longer
*2
Floor stand
Power supply unit
Air intake port
Air exhaust port
Main unit
Air exhaust port
Air intake port
Power supply unit
Advertisement
Table of Contents
