Table of Contents
Advertisement
Attention
f When a LAN cable is directly connected to the projector, cabling must be made indoors.
Note
f A LAN cable is required to use the network function via wired LAN.
f Use a straight or crossover LAN cable that is compatible with category 5 or higher. Whether either of straight/crossover cable or both cables
can be used differ depending on the system configuration. Consult your network administrator. The projector recognizes the cable type
(straight/crossover) automatically.
f Use a LAN cable of 100 m (328'1") or shorter.
Setting for projector
1)
Connect the projector and a computer using a LAN cable.
2)
Turn on the projector.
3)
Press the <MENU> button to open the [NETWORK] menu and configure settings for [WIRED LAN].
f Refer to [WIRED LAN] (x page 76) for details.
Note
f Consult your network administrator before connecting to an existing network.
f The following settings are configured as the factory defaults.
[DHCP]
[IP ADDRESS]
[SUBNET MASK]
[DEFAULT GATEWAY]
[DNS1]/[DNS2]
Setting for computer
1)
Turn on the computer.
2)
Configure network settings following the instructions of your network administrator.
f If the projector is in the factory default settings, configure the network settings of the computer side as
follows, and then you can use network functions.
[IP ADDRESS]
[SUBNET MASK]
[DEFAULT GATEWAY]
When connecting via wireless LAN
Connection example
Chapter 5 Operations — Network connection
OFF
192.168.10.100
255.255.255.0
192.168.10.1
None
192.168.10.101
255.255.255.0
192.168.10.1
IEEE802.11a/b/g/n
ENGLISH - 101
Advertisement
Table of Contents
