Table of Contents
Advertisement
3. S
ETUP
AC Power
Fuse
Replacement
Page 8 of 25
The Freedom™ Strip Hex-4 has an auto-ranging power supply and it can work with an
input voltage range of 100 to 240 VAC, 50/60 Hz. To determine the product's power
requirements (circuit breaker, power outlet, and wiring), use the current value listed on the
label affixed to the product's back panel, or refer to the product's specifications chart. The
listed current rating indicates the product's average current draw under normal conditions.
·
Always connect the product to a protected circuit (circuit breaker or fuse).
Make sure the product has an appropriate electrical ground to avoid the risk of
electrocution or fire.
·
To eliminate wear and improve its lifespan, during periods of non-use
completely disconnect from power via breaker or by unplugging it.
Never connect the product to a rheostat (variable resistor) or dimmer circuit, even if
the rheostat or dimmer channel serves only as a 0 to 100% switch.
1.
Wedge the tip of a flat-head screwdriver into the slot of the fuse holder.
2.
Pry the fuse holder out of the housing.
3.
Remove the blown fuse from the holder and replace with a fuse of the exact same
type and rating.
4.
Insert the fuse holder back in place and reconnect power.
Spare fuse holder
(inside safety cap)
Disconnect the product from the power outlet before replacing the fuse.
Installed fuse
(held by plastic clip)
Safety cap
Freedom™ Strip Hex-4 User Manual Rev. 1
Advertisement
Table of Contents
