BMW R 1200 ST User Manual page 103

The cable of the ABS
sensor could chafe
through if it comes into con-
tact with the brake disk.
Make sure that ABS sensor
cable 7 is routed correctly.c
• Install securing screws 2 for
the left and right brake cali-
pers and tighten to 30 Nm.
• Install the mudguard and
tighten securing screws 1.
• Remove the adhesive tape
from the wheel rim.
The front brakes have to be
operated a few times to bed
the brake pads against the
brake disks.
• Switch on the ignition.
• Wait for ABS self-diagnosis
to complete ( 57).
b
• Firmly pull the handbrake
lever a number of times, until
the pressure point is percep-
tible.
Braking efficiency is im-
paired if the brake pads
are not correctly bedded
against the disks.
Before riding off, check that
the brake pads are correctly
bedded against the disks.c
6
101