KitchenAid KBFA20ER Technical Education page 25

6. To remove the user interface board:
a) Disconnect the 3-wire board connec-
tor at J1.
b) Press and release the locking arm,
and disconnect the ribbon cable at
board connector J2.
c) Press and release the locking tab from
the user interface board, and remove
the board from the housing.
Wire Connector J1
User Interface Board
Locking Tab
Ribbon Cable J2
7. To remove the refrigerator door switch:
a) Slide the end of a putty knife under the
flange of the door switch, press it firm-
ly against the locking tab of the switch,
and pry the switch out of the liner.
Pry Out Door Switch
b) Disconnect the wires from the refrigera-
tor door switch terminals and remove the
switch.
8. To remove a refrigerator light socket:
a) Place the tip of a flat-bladed screw-
driver into the right slot of the light re-
flector to release the locking tab, and
lower the reflector assembly.
b) Disconnect the wires from the light
socket terminals.
c) Unsnap the refrigerator light socket
tab from the reflector and remove the
socket.
Light Socket Wires
4-3
Door Switch Wires
Light Reflector Slot
Socket Tabs