Installation Requirements; Location Requirements - Haier HCR2250ADS Installation Instructions Manual

A child or adult can tip the range and be killed.
Connect anti-tip bracket to rear range foot.
Reconnect the anti-tip bracket, if the range is moved.
Failure to follow these instructions can result in death or serious burns
to children and adults.

INSTALLATION REQUIREMENTS

LOCATION REQUIREMENTS

IMPORTANT: Observe all governing codes and ordinances. Do not obstruct flow of
combustion and ventilation air.
•
It is the installer's responsibility to comply with installation clearances specified
on the model/serial rating plate. The model/serial rating plate is located inside
the oven door on the right-hand side oven door trim.
•
The range should be located for convenient use in the kitchen.
•
Recessed installations must provide complete enclosure of the sides and rear of
the range.
•
To eliminate the risk of burns or fire by reaching over heated surface units,
cabinet storage space located above the surface units should be avoided. If
cabinet storage is to be provided, the risk can be reduced by installing a range
hood or microwave hood combination that projects horizontally a minimum of 5"
(12.7 cm) beyond the bottom of the cabinets.
•
All openings in the wall or floor where range is to be installed must be sealed.
•
Do not seal the range to the side cabinets.
•
Cabinet opening dimensions that are shown must be used.
•
Grounded electrical supply is required. See "Electrical Requirements" section.
•
Proper gas supply connection must be available. See "Gas Supply Requirements"
section.
•
Contact a qualified floor covering installer to check that the floor covering can
withstand at least 200°F (93°C).
•
Use an insulated pad or 1/4" (0.64 cm) plywood under range if installing range over
carpeting.
WARNING
Tip Over Hazard
3