Install Range; Install Anti-Tip Bracket; Electrical Connection - Haier HCR2250ADS Installation Instructions Manual

INSTALL RANGE

INSTALL ANTI-TIP BRACKET

IMPORTANT:
•
An Anti-Tip Bracket kit is included with the range. Follow the instructions
supplied with the anti-tip bracket.
•
Do not completely remove the rear leveling leg. The anti-tip bracket uses the
rear leveling leg to secure the range to the floor.
•
The anti-tip bracket should be installed, so that it secures either the right or left
rear leveling leg.
•
After installing the leveling leg, note the distance from the side of the range to
the center of the leveling leg. Mark this location on the floor.
•
Attach the anti-tip bracket to the floor with 4 screws so that the rear leveling leg
will be centered within the bracket once it is in its final position.
NOTE: Contact a qualified floor covering installer for the best procedure for drilling
mounting holes through your type of floor covering.

ELECTRICAL CONNECTION

POWER SUPPLY CORD
Disconnect power before servicing.
Use a new 40 amp power supply cord.
Plug into a grounded outlet.
Failure to do so can result in death, re or electrical shock.
1. Disconnect power.
2. Remove the terminal block cover screws located on the back of the range. Pull
cover down and toward you to remove cover.
3. Add strain relief.
10
WARNING
Electrical Shock Hazard