Sony SHAKE-X7D Operating Instructions Manual page 54

On safety

Completely disconnect the AC power
cord (mains lead) from the wall outlet
(mains) if it is not going to be used for an
extended period of time. When
unplugging the unit, always grip the
plug. Never pull the cord itself.

Should any solid object or liquid get into
the system, unplug the system, and
have it checked by qualified personnel
before operating it again.

AC power cord (mains lead) must be
changed only at the qualified service
shop.
On placement

Do not place the system in an inclined
position or in locations that are
extremely hot, cold, dusty, dirty, or
humid or lacking adequate ventilation,
or subject to vibration, direct sunlight or
a bright light.

Be careful when placing the unit or
speakers on surfaces that have been
specially treated (for example, wax, oil,
polish) as staining or discoloration of the
surface may result.

If the system is brought directly from a
cold to a warm location or is placed in a
very damp room, moisture may
condense on the lens inside the unit,
and cause the system to malfunction. In
this situation, remove the disc, and
leave the system turned on for about an
hour until the moisture evaporates.
On heat buildup

Heat buildup on the unit during
operation is normal and is not a cause
for alarm.

Do not touch the cabinet if it has been
used continuously at a high volume
because the cabinet may have become
hot.

Do not obstruct the ventilation holes.
On the speaker system
This speaker system is not magnetically
shielded, and the picture on nearby TV
sets may become magnetically distorted.
In this situation, turn off the TV, wait 15 to
30 minutes, and turn it back on. If there is
no improvement, move the speakers far
away from the TV.
54 GB
IMPORTANT NOTICE
Caution: If you leave a still video
image or on-screen display image
displayed on your TV for an extended
period of time via this system, you risk
permanent damage to your TV screen.
Projection TVs are especially
susceptible to this.
Cleaning the cabinet
Clean this system with a soft cloth slightly
moistened with a mild detergent
solution.
Do not use any type of abrasive pad,
scouring powder, or solvent, such as
thinner, benzine, or alcohol.
On BLUETOOTH communication

BLUETOOTH devices should be used
within approximately 10 meters
(unobstructed distance) of each other.
The effective communication range may
become shorter under the following
conditions.
 When a person, metal object, wall or
other obstruction is between the
devices with a BLUETOOTH
connection.
 Locations where a wireless LAN is
installed.
 Around microwave ovens that are in
use.
 Locations where other
electromagnetic waves are generated.

BLUETOOTH devices and wireless LAN
(IEEE 802.11b/g) equipment use the
same frequency band (2.4 GHz). When
using your BLUETOOTH device near a
device with wireless LAN capability,
electromagnetic interference may
occur. This could result in lower data
transfer rates, noise, or inability to
connect. If this happens, try the
following remedies:
 Use this system at least 10 meters
away from the wireless LAN
equipment.
 Turn off the power to the wireless LAN
equipment when using your
BLUETOOTH device within 10 meters.
 Use this system and BLUETOOTH
device as closer to each other as
possible.