Sony SHAKE-X7D Operating Instructions Manual page 49

 Turn off the system and reconnect
the USB device, then turn on the
system.

The music data itself contains noise,
or the sound is distorted. Noise may
have entered during the transferring
process. Delete the file, and try
transferring again.

The bit rate used when encoding
audio files was low. Send audio files
with higher bit rate to the USB device.
"READING" is displayed for an
extended time, or it takes a long time
before playback starts.
 The reading process can take a long
time in the following cases.
 There are many folders or files on
the USB device (page 10).
 The file structure is extremely
complex.
 The memory capacity is excessive.
 The internal memory is
fragmented.
"NO FILE" appears in the display
panel.
 The system has entered the software
update mode, all buttons (except
) are deactivated. Press  on
the unit to cancel the software
update.
"OVER CURRENT" appears in the
display panel.

A problem has been detected with
the level of electrical current from the
(USB) 1 port or
off the system and remove the USB
device from the port. Make sure there
is no problem with the USB device. If
this display pattern persists, contact
your nearest Sony dealer.
Erroneous display.

The data stored in the USB device
may have been corrupted, perform
the transfer again.
 The character codes that can be
displayed by this system are as
follows:
(USB) 2 port. Turn
 Upper cases (A to Z)
 Numbers (0 to 9)
 Symbols (< > * +, [ ] \ _)
Other characters appear as "_".
The USB device is not recognized.
 Turn off the system and reconnect
the USB device, then turn on the
system.
 Check the information on the website
about compatible USB devices
(page 10).

The USB device does not work
properly. Refer to the operating
instructions of the USB device on
how to deal with this problem.
Playback does not start.

Turn off the system and reconnect
the USB device, then turn on the
system.
 Check the information on the website
about compatible USB devices
(page 10).
Playback does not start from the first
file.
 Set the play mode to Normal Play
(page 23).
Files cannot be played back.

Make sure you have selected the
correct Media Mode before playback.

USB devices formatted with file
systems other than FAT16 or FAT32
are unsupported.*

If you use a partitioned USB device,
only files on the first partition can be
played back.
* This system supports FAT16 and FAT32,
but some USB devices may not support
all of these FAT. For details, refer the
operating instructions of each USB
device or contact the manufacturer.
Picture
There is no picture.

Check that the system is connected
securely.

If the video cord is damaged, replace
it with a new one.
49 GB