Connecting And Using The Audio Cable - Phiaton BT 330 NC Owner's Manual

Press the Power But-
ton and PLAY Button
simultaneously for
about 2.5 seconds
Operation
Activate
Deactivate
3) Enabling/Disabling Voice Guidance
- Within 'Pairing Mode', sliding the switch to (-) direction for about 2.5 seconds will enable voice guidance and
provide guidance when starting various features via voice. (This feature may not be supported immediately
after ending/connecting a call.)
- Within 'Pairing Mode,' again press the (-) Button for about 2.5 seconds to disable voice guidance.
* Upon factory shipment, the voice guidance feature is enabled by default.
* If the voice guidance feature is disabled, you will hear 'beep' signal tone instead of the voice guidance.
4) Resetting the Device
- To reset to factory settings, press the POWER Button and slide the switch to (+) direction simultaneously for
5 seconds simultaneously while in 'Pairing Mode'.
Operation
Factory Settings

15. CONNECTING AND USING THE AUDIO CABLE

Audio Cable
2) Activating/Deactivating the LED Indicator
- BT 330 NC is equipped with an indicator that shows operating
features to provide information on operating status.
- Press the POWER Button and the PLAY Button simultaneously for
about 2.5 seconds to deactivate the indicator (LED) that shows
operating status. To activate again, press the POWER Button and the
PLAY Button simultaneously for about 2.5 seconds.
LED Indicator
LED Display
Blank
LED Indicator
Purple light lights up twice
1) BT 330 NC can also be used with the audio cable connected as
shown in the figure.
* When connected to a device with the provided audio cable, the Bluetooth
remote features are disabled and you must use the device you are connected
to answer calls and play music.
Voice Guidance
LED activated
LED deactivated
Voice Guidance
After 'beep' signal tone twice,
"POWER ON, Pairing Mode activated"
13