Connecting And Using The Audio Cable - Phiaton BT 220 NC Owner's Manual

* The Battery Check feature will not operate while the battery is being charged.
* When the battery charge is under 3%, the alarm will sound.
If use is continued for several minutes the battery will be completely drained, the 'Power Off' voice
guidance is provided and the power will automatically turn off.
2) Activating/Deactivating the LED Indicator
- BT 220 NC is equipped with an indicator that shows operating features to provide information on
operating states.
- Press the (-) Button and (+) Button simultaneously for about 3 seconds to deactivate the indicator (LED)
that shows operating states. To activate again, Press the (-) Button and (+) Button simultaneously for
about 3 seconds.
Operation
LED Indicator
Activate
LED Display
Deactivate
Blank
3) Enabling/Disabling Voice Guidance
- Within 'Pairing Mode', pressing the PLAY Button for about 3 seconds will enable voice guidance and
provide guidance when starting various features via voice (this feature may not be supported
immediately after ending/connecting a call).
- Within 'Pairing Mode', again pressing the PLAY Button for about 3 seconds will disable voice guidance.
* Upon factory shipment, the voice guidance feature is enabled by default.
* Once the voice guidance feature is disabled, the following signal tones are provided in place of voice
guidance.
4) Resetting the Device
- To reset to factory settings, press the Play button and (+) Button for 5 seconds simultaneously while in
the Pairing Mode.
Operation
Factory Settings

16. CONNECTING AND USING THE AUDIO CABLE

1) BT 220 NC can also be used with the audio cable connected
as shown in the figure.
※ When connected to a device with the provided audio cable,
the Bluetooth remote features are disabled and you must use
the device you are connected to answer calls and play music.
- The 'LED Activated' voice guidance is provided.
- Only the'●●'↗ signal alarm is provided once through the earphones
during a call, while playing music and after a call is ended/connected.
- The 'LED Deactivated' voice guidance is provided.
- Only the'●●↘' signal alarm is provided once through the earphones
during a call, while playing music and after a call is ended/connected.
LED Indicator
Purple light lights up twice
Status
Status
After '●●' signal alarm, "POWER ON,
Pairing Mode Activated"
Audio Cable
11