Assembly - Progear Fitness 1017 Owner's Manual

ASSEMBLY

Tool:
Allen Wrench with Phillips
Screwdriver
Step 1
Connect the Sensor Wire I (#51) from the Base Frame (#26) to the Sensor
Wire II (#52) from the Handlebar Support Tube (#29). Then install the
Handlebar Support Tube (#29) to the Base Frame (#26) by inserting the
Handlebar Support Tube (#29) into the Base Frame (#26), using four Spring
Washers (#40) and four Bolts (#43). Tighten bolts with the Allen Wrench
with Phillips Screwdriver provided.
IMPORTANT: While sliding the handlebar support tube into the base frame,
make sure the wires are installed inside the handlebar support tube and pay
attention not to pinch the wires.
Hardware:
(#43) Bolt
(#40) Spring Washer
4 PCS
4 PCS
12