Maintenance & Troubleshooting - Progear Fitness 1017 Owner's Manual

WARNING: To prevent electrical shock, please turn off and unplug the
treadmill before cleaning or performing routine maintenance.
CLEANING
The treadmill can be cleaned with a soft cloth and mild detergent. Do not use
abrasives or solvents. Be careful not get excessive moisture on the display
panel as this might cause an electrical hazard or electronics to fail.
Please keep the treadmill, especially the console out of direct sunlight to
prevent screen damage.
TROUBLESHOOTING GUIDE
Problem
Treadmill will not
start.
Belt slips.
Belt hesitates
When stepped
on.
Belt is off centered.
MAINTENANCE &
TROUBLESHOOTING
TROUBLESHOOTING
Potential Causes
1. Not plugged in.
2. ON/OFF Switch
3. Safety tether key not
connected.
4. House circuit breaker
tripped.
5. Treadmill circuit breaker
tripped.
Belt not tight enough.
1. Not enough lubrication
applied onto the running
deck.
2. Belt is too tight.
Running belt tension is not
even across the rear roller.
1. Put the power plug into the
electrical wall outlet.
2. Check Master Power Switch
that is located at the front of the
treadmill.
3. Install the safety tether key.
4. Reset or have an electrician
replace the breaker in home.
5. Wait five minutes and then
press the switch back on.
Adjust belt tension.
1. Apply silicone lubricant.
2. Adjust the belt tension.
Center the belt.
20
Corrections