Cleaning The Water Inlet Filter; Cleaning The Drain Pump Filter - Daewoo DWD-F1011 Service Manual

Cleaning the water inlet filter

Cleaning the water inlet filter
• "IE" error message will blink on the control panel when water does not enter the detergent drawer. • "IE" error message will blink on the control panel when water does not enter the detergent drawer.
• If your water is very hard or contains traces of lime deposit, the water inlet filter may become clogged. • If your water is very hard or contains traces of lime deposit, the water inlet filter may become clogged.
• It is therefore a good idea to clean it from time to time. • It is therefore a good idea to clean it from time to time.

Cleaning the drain pump filter

• The drain filter collects threads and small objects left in the laundry.
• Check regularly that the filter is clean to ensure smooth running of your machine.
CAUTION Be careful when draining if the water is hot.
1. Open the lower cover(1) by
using a coin. Turn the cap
hose(2) to pull out the hose.
Pull out the hose maximally.
(About 13~14cm.)
100
1. Turn off the
water tap.
3. Clean the filter
using a had
bristle brush.
2. Unplug the cap hose(2), allowing
the water to flow out. At this time use
a vessel to prevent water flowing on
to the floor. When water does not
flow any more, turn the pump
filter(3) open to the left.
about
13~14cm
1
2
3. Remove any foreign material
from the pump filter(3). After
cleaning, turn the pump filter
clockwise and insert the cap
hose(2) to the original place.
Close the lower cover.
3
2
2. Unscrew the
water inlet
hose.
4. Tighten up the
inlet hose.
about
3
13~14cm
MAINTENANCE
11