Set-Up Of The Receiving Tray; Paper Feeding; For The Tf Mini Plus (1 Single Feeding Station); For The Tf Multi Plus (3 Feeding Stations) - Hefter TF MINI plus Operating Manual

2. PREPARATION FOR USING THE FOLDER

2.3. Set-up of the receiving tray

Pull out the drawer for the paper tray at the front of the machine (-> photo 03
and 05). Adjust the position needed (stacking width) by moving the drawer
accordingly. No jam may occur (The scores at the drawer help you to find the
correct stacking width)!

2.4. Paper feeding

2.4.1 Paper feeding at the TF MINI plus (= one single feeding station, see photo 06)
Adjust both paper guidances centered and
symmetric and with a minimal slack
to the paper width needed.
To adjust the paper guidances please grab
them with the clambing lever.
NOTE: No jam may occur at the paper
guidance,
the paper needs a slack of ~0,5 mm!
Move the lever of the paper tray (right side)
downwards and position the paper so that it
touches the bottom neatly. Then loose the lever.
Example: For the set-up of the wrap fold for A4 sheets (see point 3.4.1) feed the
paper face up and foot first.
Tip: - Fan the paper before you insert it!
Always make a test fold to check the fold!
-
2.4.2 Paper feeding at the TF MULTI plus (= 3 feeding stations, see photo 07)
Adjust both paper guidances of each feeding
station centric and symmetric and with a
minimal slack to the paper width needed.
Please use the scale for that purpose.
To adjust the paper guidances please grab
them with the clambing lever.
NOTE: No jam may occur at the paper guidance,
the paper needs a slack of ~0,5 mm!
Move the lever of the paper tray (right side)
downwards and position the paper so that it
touches the bottom neatly. Then loose the lever.
Abb. 06
TF MINI plus
plus
Abb. 07 – TF MULTI
7