Names And Functions Of; The Operating Section - Daikin BRC4C65 Operation Manual

To avoid injury, do not touch the air
inlet or aluminium fins of the unit.
Do not place objects in direct proxim-
ity of the outdoor unit and do not let
leaves and other debris accumulate
around the unit.
Leaves are a hotbed for small animals
which can enter the unit. Once in the unit,
such animals can cause malfunctions,
smoke or fire when making contact with
electrical parts.
Never touch the internal parts of the
controller.
Do not remove the front panel. Touching
certain internal parts will cause electric
shocks and damage to the unit. Please
consult your dealer about checking and
adjustment of internal parts.
Do not leave the remote controller
wherever there is a risk of wetting.
If water gets into the remote controller
there is a risk of electrical leakage and
damage to electronic components.
Do not locate inverter fluorescent
lamps or intensive light sources close
to the receiver of the indoor unit if the
wireless remote controller is used, or
otherwise the air conditioner may mal-
function.
Watch your steps at the time of air fil-
ter cleaning or inspection.
High-place work is required, to which
utmost attention must be paid.
If the scaffold is unstable, you may fall or
topple down, thus causing injury.
2. NAMES AND FUNCTIONS
OF THE OPERATING SEC-
TION (Fig. 1, 2)
DISPLAY "
(SIGNAL TRANSMISSION)
1
This lights up when a signal is being
transmitted.
English
"
DISPLAY "
" " (OPERATION MODE)
This display shows the current OPER-
2
ATION MODE. For straight cooling
type, " " (Auto) and "
are not installed.
H M
DISPLAY "
3
(SET TEMPERATURE)
This display shows the set temperature.
DISPLAY "
hr.
(PROGRAMMED TIME)
4
This display shows PROGRAMMED
TIME of the system start or stop.
DISPLAY " " " " " " (FAN SPEED)
5
The display shows the set fan speed.
DISPLAY "
TEST OPERATION)
6
When the INSPECTION/TEST OPER-
ATION BUTTON is pressed, the display
shows the system mode is in.
ON/OFF BUTTON
Press the button and the system will
7
start. Press the button again and the
system will stop.
FAN SPEED CONTROL BUTTON
8
Press this button to select the fan
speed, HH or H or L, of your choice.
TEMPERATURE SETTING BUTTON
Use this button for SETTING TEMPER-
9
ATURE (Operates with the front cover
of the remote controller closed.)
PROGRAMMING TIMER BUTTON
Use this button for programming
10
"START and/or STOP" time. (Operates
with the front cover of the remote con-
troller opened.)
TIMER MODE START/STOP BUTTON
11
Refer to page 9.
TIMER RESERVE/CANCEL BUTTON
12
Refer to page 10.
" " " " " "
" (Heating)
L
"
C
"
hr.
" (INSPECTION/
TEST
"
4