Installation manual Self Cleaning decoration panel BYCQ140CGW1 CAUTION CONTENTS • Install the indoor and outdoor units, power cord, remote controller 1. SAFETY PRECAUTIONS ............1 wiring, and transmission wiring at least 1m away from TV or radio sets. This is for the prevention of TV and radio interference.
Mounting directions of suction grille. Note Select one of the following mounting directions of the suction grille Do not impose force on the swing fl ap, brush unit, or air fi lter on the panel. when handling the panel. Drain Air filter Brush unit socket...
Turn the two fi xing knobs of the dust box. Attaching spacer (accessory (1)). Fixing knob Indoor unit Dust box Remove the bypass hole closure material, and peel off the seal and holding tape. 3 Holding tape Seal Fixing knob Bypass hole (The front side of the panel is shown for ease of explanation.) Indoor unit...
Connect the harness (accessory (4)) to the connectors (X35A Note and X70A) and the three points of the harness on the unit side. Leave your hands after confi rming that the mounting brackets are engaged with the hooks. Tighten the four hexagon head screws right under the X70A X35A Connector...
Page 7
Note Note • Tighten the screws securely, or otherwise a defect as shown Accommodate the lead wires carefully so that the lead wires below may result. will not come in contact with the air fi lter. • Readjust the height of the indoor unit if there is a space between the ceiling and panel with the screws tightened securely.
Turn the fi xing knobs (in two points) of the dust box and secure Hook (A). the dust box. Set the suction grille to an angle of approximately 45° and put the hooks (in three points) onto the panel. Fixing knob Display on SUCTION GRILLE HOOKING SIDE...
Page 9
Press fi t the fl exible hose connected in (3) into the panel. Hook (B). (Pay attention so that the hose will not be caught by the Set the suction grille to an angle of approximately 45° and put suction grille closed.) the hooks (in three points) onto the panel.
Page 10
Press fi t the fl exible hose connected in (3) into the panel. Attaching decoration corner covers. Pay attention so that the hose will not be caught by the suction Connect the decoration corner cover (with the display) grille closed. securely to the PCB in the order opposite to the procedure in To suction grille “4.
OPERATION MODE SETTINGS 10-1 Check that the EL. COMPO. BOX lids of the indoor unit, outdoor unit, and self-clean Any one of the following operation modes can be selected for the panel, respectively, are closed. fi lter auto cleaning of the self-clean panel. Operation mode Description 10-2...