Daikin BRC4C65 Operation Manual page 14

Press the PROGRAMMING
2
TIMER button and set the time
for stopping or starting the system.
When this button is pressed, the
time advances by 1 hour.
UP
When this button is pressed, the
time goes backward by 1 hour.
DOWN
Press RESERVE button.
3
The timer setting procedure ends.
The display changes from flashing light to a
constant light.
NOTE
• When setting the timer Off and On at the
same time, repeat the above procedure
from to
1
3
For example.
ON OFF
TEMP
TIME
C
UP
DOWN
FAN
RESERVE CANCEL
hr.
TIMER
hr.
MODE
• After the timer is programmed, the display
shows the remaining time.
• Press the TIMER OFF button to cancel
programming. The display vanishes. (
English
once again.
When the timer is
programmed to stop
the system after
3 hours and start the
system after
4 hours, the system
will stop after
3 hours and then
1 hour later the sys-
tem will start.
HOW TO SET MASTER REMOTE
CONTROLLER
(For VRV system)
• When the system is installed as shown
below, it is necessary to designate the
master remote controller.
〈〈For Heat pump system〉〉
When one outdoor unit is connected with
several indoor units.
One of these remote controllers
needs to be designated as the
master remote controller.
〈〈For Heat recovery system〉〉
When one BS unit is connected with several
indoor units.
)
4
One of these remote controllers
needs to be designated as the
master remote controller.
Outdoor unit
Outdoor unit
BS unit
Indoor
unit
Indoor
unit
10