Daikin BRC4C65 Operation Manual page 17

Press the INSPECTION/TEST
1
button to select the inspection
mode " ".
" " appears on display and blinks. "UNIT"
lights up.
Press PROGRAMMING TIMER
2
BUTTON and change the unit
number.
Press to change the unit number until the
indoor unit beeps and perform the following
operation according to the number of beeps.
Number of beeps
3 short beeps .....Perform all steps from
to
1 short beep .......Perform
steps
1 long beep ........Normal state
Press OPERATION MODE
3
SELECTOR BUTTON.
" " on the left-hand of the malfunction code
blinks.
Press PROGRAMMING TIMER
4
BUTTON and change the mal-
function code.
Press until the indoor unit beeps twice.
Press OPERATION MODE
5
SELECTOR BUTTON.
" " on the right-hand of the malfunction
code blinks.
Press PROGRAMMING TIMER
6
BUTTON and change the mal-
function code.
Press until the indoor unit makes a long
beep.
The malfunction code is fixed when the
indoor unit makes a long beep.
Reset of the display.
7
Press OPERATION MODE SELECTOR
BUTTON to get the display back to the nor-
mal state.
13
6
and
6
3
II. IN CASE BESIDES EMERGENCY STOP
1. The unit does not operate at all.
• Check if the receiver is exposed of sun-
light or strong light. Keep receiver away
from light.
• Check if there are batteries in the
remote controller. Place the batteries.
• Check if the indoor unit number and
wireless remote controller number are
equal.
3
Operate the indoor unit with the remote con-
troller of the same number.
Signal transmitted from a remote controller of
a different number cannot be accepted. (If
the number is not mentioned, it is considered
as "1")
2. The system operates but it does not
sufficiently cool or heat.
• If the set temperature is not proper.
• If the FAN SPEED is set to L SPEED.
• If the air flow angle is not proper.
Contact the place of purchase in the fol-
lowing case.
WARNING
When you detect a burning odor, shut
OFF power immediately and contact the
place of purchase. Using the equipment
in anything but proper working condition
can result in equipment damage, electric
shock and/or fire.
Number
English