Electrolux FPRH17D7KF All Refrigerator Professional Series Servicing page 61

All Freezer-Pro
Door Shelf Guard Removal
The door shelf guard is secured to the inner door panel
with two tabs on each end.
To remove the door shelf guard, bend the door shelf
guard out in the middle while bending out the outer
portion of the inner panel outwards, then pull the tabs
of the door shelf guard out of the inner panel.
(See Figure 5-36)
Tilt Out Wire Shelf Removal
The tilt out wire shelves have a bar that locates in the
end caps that enable the wire shelves to tilt outward.
The end caps have two standoffs that snap into holes in
the inner panel.
To remove the tilt out wire shelves:
1. Flex the inner panel outward and lift the wire shelf
out of the end cap. Then pull the opposite end of
the wire shelf out of the opposite end cap.
(See Figure 5-37)
2. The end caps are removed by simply pulling the end
caps out of the inner panel.
Door Switch Removal
The door switch is mounted inside a hole in the cabinet
base along the lower left hand side. (See Figure 5-38)
To remove the door switch:
1. Remove kickplate.
2. Reach into the access hole next to the door switch
and disconnect the electrical leads from the door
switch terminals.
3. Press in on the retaining latch on the switch body
and push switch through hole in cabinet base.
Section 5 Component Teardown
Bend Out
Here
Bend Here
Figure 5-36. Door Shelf Guard Removal
End Cap
Wire Tilt-out Shelf
Figure 5-37. Door Lock Removal
Door Switch
Access Hole
Figure 5-38. Door Switch Removal
Door Shelf Guard
End Cap
5-17