Attaching Slide-Bar To Cupboard Door - Electrolux WTB3100 Installation Manual

14
aTTaChIng SlIdE-BaR To ThE CuPBoaRd dooR
1. Fully open cupboard door (120°).
2. open refrigerator door until it rests against the
cupboard door.
3. Position slide-bar in slide-housing so that all three
holes are visible when both doors are fully open (120°).
This position is typically 125mm from the edge of the
cupboard door (Figure 14).
Figure 14
120º
cupboard door
refrigerator door
slide bar
Figure 15
125mm
Figure 16
Whilst slide-bar is still in housing:
4. Rotate slide-bar to uppermost alignment, mark a line
on cupboard door (Figure 15).
5. Rotate slide-bar to lower alignment, mark a line on
cupboard door (Figure 16).
6. Remove slide-bar and draw line to indicate central
alignment (Figure 17).
7. Replace slide-bar and align to centre line marked in
previous operation (Figure 18).
8. Secure slide-bar by driving a cupboard screw into the
centre of the inner slot (Figure 19).
gently test closing of door.
9. If the action is smooth and the slider does not move in
relation to the cupboard door, drive another cupboard
screw into the end slot (Figure 20).
10. open and close the door a number of times if the
action is not smooth. loosen the screws and re-adjust
slide-bar. once the desired smooth action is achieved
attach the central locking screws (Figure 21).
Figure 17 Figure 18