Setting Up The Trim And Grill Assembly - Electrolux FPRH17D7KF All Refrigerator Professional Series Servicing

Setting Up The Trim And Grill Assembly

1. Lay the parts out on a cleared area face down. Be
sure to place a drop cloth over the floor to prevent
scratching the trim kit and/or floor. (See Figure 2-9).
Figure 2-9.
2. Slide top grill (E) and bottom grill (D) together.
Make sure the ends are flush then tape together to
prevent parts from sliding. (See Figure 2-10).
Figure 2-10.
3. Slide grill assembly into top collar trim (A). Tape
together to prevent from sliding. (See Figure 2-11).
Section 2 Installation Information
Figure 2-11.
4. Attach brackets (K) to the angled end of each side
trim (B and C). Gently secure brackets to side trim
by tightening set screws (L) only until snug to avoid
dimpling the extrusion face. DO NOT overtighten.
(See Figure 2-12).
Figure 2-12.
5. Join each side trim (B and C) to the top trim (A).
Make sure the ends of the Grill Assembly are
captured in the channel of each side trim, then tape
in place. Gently secure brackets (K) to top trim (A)
by tightening set screws (L), only until snug to avoid
dimpling the trim face. DO NOT overtighten. (See
Figure 2-13).
.
Figure 2-13.
2-9