Nylon Line Head Disassembly Instructions - Echo PAS-225 Operator's Manual

MAINTENANCE
4. Remove coupler (E) from upper drive shaft assembly by
loosening clamping screw (C) and removing set screw (D).
5. Remove upper flex cable (F), wipe clean, and apply a thin
coating of 15 ml (1/2 oz.) of grease.
6. Install cable. Make sure that the flex cable fully engages into
the clutch square drive socket.
7. Slide coupler on upper drive shaft until fully seated, and
align set screw hole in coupling with hole in upper drive
shaft.
8. Install and tighten set screw (D), and tighten clamping screw
(C).

Nylon Line Head Disassembly Instructions

Note: For normal use, Speed Feed® head disassembly is not
necessary. However, if circumstances require
disassembly, follow these instructions.
1. Press top of locking tabs (A) on both sides of Speed
Feed® head to release cover (B) from eyelet carrier (C).
2. Remove cover from eyelet carrier.
30
PAS-225VPB
E
A
F
A
C
D
B
B
X7722278200
© 11/2014 ECHO Inc.